Avenger V6-2.7L (2008)
Fuel Gauge Sender: Description and Operation
Operation
OPERATION
The fuel pump module is located inside the fuel tank with an integral fuel level sensor and pressure regulator. The pump is driven by a 12 volt DC motor
any time the fuel pump relay is energized.
The pump draws fuel through a internal filter and pushes it through the motor to an outlet pipe. The pump contains two check valves. One valve relieves
internal fuel pump pressure and regulates maximum pump output. The second valve, in the pump outlet, maintains pump pressure during engine off
conditions.
The fuel system uses a positive displacement, gerotor, with a permanent magnet electric motor. The regulator contains a calibrated spring which forces a
diaphragm against the fuel filter return port. When pressure exceeds the calibrated amount, the diaphragm retracts, allowing excess fuel pressure in the
fuel pump module to purge into the fuel tank.
The maximum deadhead pressure is approximately 880 kPa (130 psi). The regulator adjusts fuel system pressure to approximately 400 ±34 kPa (58 ± 5
psi).
The electric fuel pump is not serviceable. If the fuel pump or electrical wiring harness needs replacement, the complete fuel pump module must be
replaced. Perform the Fuel System Pressure Release procedure before servicing the fuel pump.