Avenger V6-2.7L (2008)
7. Cut the trim piece at points (1) as shown and remove.
8. Remove the drivers surround bezel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Driver
Surround Bezel/Removal
9. Remove the instrument cluster See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster / Carrier/Service and Repair/Instrument
Cluster/Instrument Cluster - Removal.
10. Reach up behind the left side of the center stack and disconnect the ignition switch electrical connector (6) and the WCM electrical connector (5).
11. Insert the ignition key into the ignition cylinder. Push the shift interlock cable locking tab inward and rotate the ignition key to the on position.
This will release the cable from the ignition switch. Remove the shift interlock cable from the ignition cylinder.
12. Remove the ignition switch support bracket screw (1).
