Avenger V6-2.7L (2008)
b.
Touch the screen to highlight the TCM in the list of modules.
c.
Select "More Options"
d.
Select "ECU Flash"
e.
Record the part number at the top of the "Flash TCM" screen for later reference.
f.
Select "Browse for New File". Follow the on screen instructions.
12.
Is the part number recorded in step lie above, the same as the new pin shown on the "Flash File List" screen?
a.
Yes >> TCM controller reprogramming is not necessary. Proceed to step 13.
b.
No >> TCM controller will require flash reprogramming, proceed to TCM Repair Procedure. Start with step 9.
NOTE:
The following step is required by law when reprogramming a PCM and/or TCM.
13.
Type the necessary information on the "Authorized Modification Label" p/n 04275086AB and attach near the VECI label (Fig. 1).
TCM REPAIR PROCEDURE - USING THE INTERNET TO RETRIEVE THE FLASH FILE:
CAUTION:
EXTREME CARE MUST BE TAKEN WHEN PROGRAMMING A CALIBRATION INTO A GENERIC PCM OR TCM. DO NOT
RANDOMLY SELECT A CALIBRATION. ONCE A CALIBRATION IS SELECTED AND PROGRAMMED, THE CONTROLLER CANNOT
BE REPROGRAMMED TO A DIFFERENT APPLICATION. THE MODULE CAN ONLY BE REPROGRAMMED TO A MORE RECENT
VERSION OF THAT SAME CALIBRATION.
1.
Using the StarSCAN(R) attempt to read/record the part number of the existing controller before removing it from the vehicle. This part number
can be used to identify the correct calibration for down load.
2.
Replace the controller using the steps outlined in DealerCONNECT / TechCONNECT.
NOTE:
When performing this Repair Procedure, the software release level in the StarSCAN(R); must be programmed with 7.03 software or higher. The
software release level is visible in the blue header at the top of the StarSCAN(R) screen.
NOTE:
The StarSCAN(R) diagnostic scan tool fully supports Internet connectivity. However, to take advantage of this feature you must first configure the
StarSCAN(R) for your dealership's network. Make sure the StarSCAN(R) is configured to the dealership's network before proceeding. For
instruction on setting up your StarSCAN(R) for the dealer's network refer to either:
"DealerCONNECT > Service > StarSCAN and StarMOBILE tools > Online Documentation", or refer to the StarSCAN® Quick Start Networking
Guide. The StarSCAN(R) Quick Start Networking Guide is also available on the website under the "Download Center".
