Avenger V6-2.7L (2008)
Repairs and Inspections Required After a Collision: Service and Repair
SERVICE AFTER AN AIRBAG DEPLOYMENT
WARNING: To avoid serious or fatal injury on vehicles equipped with the Supplemental Restraint System (SRS), never attempt to repair the
electrically conductive circuits or wiring components related to the SRS. Such repairs can compromise the conductivity and current carrying
capacity of those critical electrical circuits, which may cause SRS components not to deploy when required, or to deploy when not required.
Any wire harness containing broken, cut, burned or otherwise damaged electrically conductive SRS wiring, terminals or connector components
must be removed and replaced with an entire new wire harness. Only minor cuts or abrasions of wire and terminal insulation where the
conductive material has not been damaged, or connector insulators where the integrity of the latching and locking mechanisms have not been
compromised may be repaired using appropriate methods.
DRIVER AIRBAG
After a Driver Airbag has been deployed due to a collision, the following MUST be replaced:
-
Driver Airbag
-
Clockspring Assembly
-
Steering Wheel
-
Complete Steering Column Assembly with Lower Steering Column Coupler
All other airbag and vehicle components should be closely inspected following any airbag deployment, and should be replaced when visible damage is
incurred.
WARNING: Do not connect the battery negative cable See: Air Bag Systems/Testing and Inspection. Serious or fatal injury may result if the
system test is not performed first.
PASSENGER AIRBAG
After a Passenger Airbag has been deployed due to a collision, the following MUST be replaced:
-
Passenger Airbag
-
Instrument Panel Top Pad
All other airbag and vehicle components should be closely inspected following any airbag deployment, and should be replaced when visible damage is
incurred.
WARNING: Do not connect the battery negative cable See: Air Bag Systems/Testing and Inspection. Serious or fatal injury may result if the
system test is not performed first.
SEAT AIRBAG
After a Seat Airbag has been deployed due to a collision, the following MUST be replaced:
-
Complete Seat Back Assembly
All other airbag and vehicle components should be closely inspected following any airbag deployment, and should be replaced when visible damage is
incurred.
WARNING: Do not connect the battery negative cable See: Air Bag Systems/Testing and Inspection. Serious or fatal injury may result if the
system test is not performed first.
CURTAIN AIRBAG
After a Curtain Airbag has been deployed due to a collision, the following MUST be replaced:
-
Curtain Airbag Assembly
-
Headliner
-
A, B, C, and D-pillar trim on deployed side.
All other airbag and vehicle components should be closely inspected following any airbag deployment, and should be replaced when visible damage is
incurred.
WARNING: Do not connect the battery negative cable See: Air Bag Systems/Testing and Inspection. Serious or fatal injury may result if the
system test is not performed first.