Avenger V6-2.7L (2008)
19.
Turn off the StarMOBILE scan tool and then restart the scan tool.
NOTE:
The StarMOBILE scan tool must be shut down and restarted to unlock the flash.
20.
From the "System Status" screen press the "Exit" button.
21.
From the "Main Menu" select "Enter Standalone Diagnostic Mode" and press the select button.
22.
Select "ECU View" and press the select button.
23.
Highlight "TIPMCGW" and press the select button.
24.
Select "FLASH ECU" and press the select button.
25.
Compare the highlighted software part number with the software part number displayed at the top of the screen.
>
If the part numbers are the same, the module is up to date and reprogramming is not required. Continue to Step 28.
>
If the software part numbers are different, press the select button to reprogram the module.
26.
Verify the file number on the screen. If correct press the select button and follow the screen prompts.
27.
When the flash is complete, press the "OK" button.
28.
Clear any Diagnostic Trouble Codes (DTCs) as follows:
NOTE:
Due to the TIPM programming procedure, DTC(s) may be set in other modules (PCM, TCM, ABS, BCM, MIC, WCM, etc.) within the
vehicle, if so equipped. Some DTC's may cause the MIL to illuminate.
a.
From the "Standalone Home" screen highlight "All DTC's and then press the select button.
b.
Highlight "Clear All Stored" and then press the select button.
c.
Follow the screen prompts on the StarMOBILE screen.
29.
Turn the ignition key to the "OFF" position and remove the StarMOBILE unit, StarMOBILE cable, and battery charger from the vehicle.
C. Install the Authorized Modifications Label
1.
Type or print (with a ballpoint pen) the recall number, dealer code and date on the Authorized Modifications Label (Figure 1).
2.
Attach the label near the VECI label and then close the hood.
3.
Complete Proof of Correction Form for California Residents.
NOTE:
This recall is subject to the State of California Registration Renewal/Emissions Recall Enforcement Program. Complete a Vehicle Emission Recall
Proof of Correction Form (Form No. 81-016-1053) and supply it to vehicle owners residing in the state of California for proof that this recall has
been performed when they renew the vehicle registration.
