Avenger V6-2.7L (2008)
8. Release the lower ball joint (5) from the lower control arm (1) using Remover (2), Special Tool 9360. Do not lift the knuckle out of the lower
control arm at this time.
9. Lift the knuckle (2) out of the lower control arm (5).
NOTE: Do not allow the half shaft (1) to hang by the inner C/V joint; it must be supported to keep the joint from separating during this
operation.
10. Pull the knuckle (2) off the axle half shaft (1) outer C/V joint splines and support the half shaft.
