Avenger V6-2.7L (2008)
Control Arm: Service and Repair
Rear Suspension
Removal
REMOVAL
1. Raise and support the vehicle. See: Maintenance
2. Remove the mounting bolt (2) and nut securing the toe link (3) to the knuckle.
3. Mark the position of the cam bolt cam on the crossmember using a paint marker or crayon. Do not use any type marker that will scratch or damage
the surface of the crossmember.
4. While holding the cam bolt (4) head stationary, loosen and remove the toe link mounting cam bolt nut (3) and washer (1). Remove the cam bolt.
5. Remove the toe link (2).
Installation
INSTALLATION
CAUTION: When installing the cam bolt (4) and washer make sure the cams stay inside the abutments built into the crossmember. Failure to
do so can damage the abutments and make toe adjustment difficult.
1. Position the toe link (2) and install the cam bolt (4) from the front through the crossmember and link. Match the cam on the bolt to the marks made
during removal or position the top of the cam to the 12 O'clock position.
