Avenger V6-2.7L (2008)
1. Position the lower control arm (3) and install the bolt (6) and nut (4) securing the lower control arm to the crossmember (5). Do not tighten at this
time.
2. Install the bolt (7) and nut (2) securing the lower control arm (3) to the knuckle (1). Do not tighten at this time.
3. Install the mounting bolt (4) and nut (1) fastening the shock assembly (2) to the lower control arm (3). Do not tighten at this time.
NOTE: When attaching a stabilizer bar link to the lower control arm it is important that the lower mounting stud be positioned properly. The
lower mounting stud on the right side link needs to point toward the front of the vehicle when inserted through the lower control arm mounting
flange. The left side link lower stud needs to point toward the rear of the vehicle. Otherwise the suspension geometry will not function properly.
4. If equipped, attach the stabilizer bar link (2) to the lower control arm (4). Install the nut (3) and while holding the stabilizer bar link lower stud
stationary, tighten the nut (2) to 48 Nm (35 ft. lbs.).
