Avenger V6-2.7L (2008)
5. Rotate the disc brake caliper downward over the brake rotor and lower part of caliper adapter.
6. Install the disc brake caliper (2) lower guide pin bolt (1). Tighten the guide pin bolt to 60 Nm (44 ft. lbs.).
7. Clean all foreign matter from the threads of the half shaft outer C/V joint.
8. Install the washer (4) and hub nut (3) on the end of the half shaft and snug it.
9. While a helper applies the brakes to keep the hub (1) from rotating, tighten the hub nut (3) to 245 Nm (181 ft. lbs.).
10. Insert the cotter pin (2) through the notches in the nut and the hole in half shaft. If the notches in the nut do not line up with the hole in the half
shaft, continue to tighten the nut until they do. Do not loosen the nut.
11. Wrap the cotter pin (2) ends tightly around the lock nut.
