Avenger V6-2.7L (2008)
Transmission Cooler: Procedures
Standard Procedure
QUICK CONNECT FITTING DISASSEMBLY/ASSEMBLY
DISCONNECT
1. Remove dust cap by pulling it straight back off of quick connect fitting (1).
2. Place Release Tool 8875A (4) onto transmission cooler line with the fingers of the tool facing the quick connect fitting.
3. Slide Release Tool 8875A down the transmission line and engage the fingers of the tool into the retaining clip. When properly engaged in the clip,
the tool will fit flush against the quick connect fitting.
4. Rotate the release tool 60° to expand the retaining clip.
5. While holding the release tool against the quick connect fitting, pull back on the transmission cooler line to remove.
6. If quick connect fitting is damaged or leaking at transmission oil cooler or transmission, remove fitting.
CONNECT
