Avenger V6-2.7L (2008)
Drive/Propeller Shaft: Service and Repair
Propeller Shaft - Installation
INSTALLATION
CAUTION: Propeller shaft installation. Never allow propeller shaft to hang while connected to Power Transfer Unit (PTU), rear driveline
module flanges or center bearings. If propeller shaft section is hung unsupported, damage may occur to joint, boot and/or center bearing from
over-angulation. This may result in vibration/balance issues. A helper may be needed.
1. Make sure transaxle is in Neutral (N) position.
2. Obtain a helper if needed and lift propeller shaft assembly into position. Install propeller shaft to PTU with mounting bolts and tighten to 30 Nm
(22 ft. lbs.).
