Avenger V6-2.7L (2008)
Power Window Control Module: Service and Repair
Installation
INSTALLATION
NOTE: The C2 connector of the driver door module must be connected prior to the C1 connector. If this is not done, the scan tool will report
multiple passenger door modules. In order to correct this situation, remove fuse #36 for approximately 30 seconds and reinstall the fuse.
1. Install the module and mounting fasteners.
2. Connect the electrical connectors.
3. Install the door trim panel. See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair/Front Door
Trim Panel - Installation.
4. Connect the battery negative cable.