Avenger V6-2.7L Flex Fuel (2009)
Seat Cover: Service and Repair
Seat Back Cover - Removal
Front
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the headrest from the seat.
3. Remove the seat from vehicle.See: Service and Repair/Seat - Removal.
4. Remove the seat back from the seat frame. See: Seat Back/Service and Repair/Seats, Front Sedan/Front Seat Back Recliner - Removal
5. Remove the seat back cover panel by carefully prying out the lower end of the cover and disengaging the bottom and side spring clip retainers.
6. Once the four spring clip retainers are disengaged, push upward on the cover toward the top of the seat back, and pull the top of the cover outward
to disengage from the spring retainers.
7. Remove the two lower push-pins securing the seat cover.
8. Disengage the J-hooks securing the seat back cover to the frame.
9. Remove the black foam from under the seat back cover.
10. While squeezing the tabs on the headrest sleeves, gently tap the bottom of the sleeve with a rubber mallet and remove from the seat back.
