Avenger V6-2.7L Flex Fuel (2009)
5. Using Mopar(R) Lubriplate, or an equivalent, coat the surface of the brake pedal pin (3) where it contacts the brake booster push rod (1).
6. Install the power brake booster push rod (1) on the pin (3) mounted on the side of the brake pedal. Install a NEW retaining clip (2) on the end of
the pin. Do not reuse the old clip.
7. Install and adjust the stop lamp switch in the brake pedal bracket See: Lighting and Horns/Brake Light Switch/Service and Repair/Stop Lamp
Switch - Installation
8. If equipped, Install the clutch pedal blocker (1) using three mounting screws.
9. Install the steering column cover reinforcement (1) using the four mounting screws (2).
10. Install the steering column opening cover on the instrument panel. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Steering Column Opening Cover - Installation
11. If equipped, install the silencer pad below the instrument panel.
