Avenger V6-2.7L Flex Fuel (2009)
5. Install the tire and wheel assembly (1) See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels -
Installation. Tighten the wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
6. Lower the vehicle.
7. Pump the brake pedal several times before moving the vehicle to set the pads to the brake rotor.
8. Check and adjust the brake fluid level in the reservoir as necessary.
9. Road test the vehicle and make several stops to seat the brake pads to the rotor.
Rear
REAR BRAKE ROTOR
NOTE: Inspect disc brake pads and parking brake shoes before installation. See: Brake Pad/Service and Repair/Procedures/Brake Pads -
Inspection
1. Clean the hub face (1) to remove any dirt or corrosion where the rotor mounts.
2. Install the brake rotor (2) over the studs on the hub and bearing.
CAUTION: Use care when installing the caliper onto the adapter bracket to avoid damaging the guide pin boot.
3. Rotate the disc brake caliper downward over the brake rotor and lower part of caliper adapter.
4. Install the disc brake caliper (2) lower guide pin bolt (1). Tighten the guide pin bolt to 43 Nm (32 ft. lbs.).
