Avenger V6-2.7L Flex Fuel (2009)
1. With the engine not running, pump the brake pedal 4-5 strokes until the pedal feel is firm.
2. Disconnect the negative (ground) cable from the battery and isolate the cable.
3. Remove the wiring harness connector (1) from the brake fluid level switch (2) in the master cylinder brake fluid reservoir.
4. Disconnect the two front brake tubes (1, 3) from the master cylinder (2). Install plugs at the open brake tube outlets on the master cylinder.
5. Disconnect the two rear brake tubes (1, 2) from the proportioning valves on the master cylinder (3). Install plugs at the open brake tube outlets on
the proportioning valves.
