Avenger V6-2.7L Flex Fuel (2009)
7. Pull the brake tube bundle routing clip (with tubes) loose from the stud on the right side of the dash panel.
NOTE: Use this figure in the following step to release the ABM harness connector cover. It shows the location of the release tabs.
8. Disconnect the ABM harness connector from the Antilock Brake Module (ABM). To do so:
a. Depress the tabs on each side of the connector cover, then
b. Pull outward and upward on the lower half of the cover until it locks into position pointing straight outward (2). The connector can then be
pulled straight outward off the ABM (1).