dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Parking Brake Cable|Removal|Page 5004 > < Parking Brake Cable|Removal|Page 5002
Page 3
background image

11. Route the parking brake cable under the carpeting, up to the parking brake cable retaining bracket (2) on the floor pan. Insert the parking brake

cable (3) through the mounting hole in the retaining bracket. Push the cable in until the locking fingers on the cable retainer (1) lock the cable into
place.

CAUTION: A NEW parking brake cable equalizer (2) must be installed when servicing the parking brake cables or lever. The equalizer has an

integrated bent nail tensioner that needs to be stretched upon installation placing the correct tension on the cables.

12. Remove and install a NEW parking brake cable equalizer (2) on the parking brake lever (3) output cable.
13. Install the rear parking brake cables (1) into the equalizer (2) on the parking brake lever output cable.
14. Ensure that the parking brake cables are correctly installed on the equalizer and aligned with the cable track on the parking brake lever.

NOTE: Actuating the parking brake lever to its fully applied position one time after tightening the adjustment nut will yield (stretch) the bent

nail portion of the equalizer approximately 1/4 inch (6 mm). This process will correctly set the parking brake cable tension.

15. Adjust parking brake cable tension using the following steps:

a. Place the parking brake lever in the fully released (down) position.
b. Tighten the adjusting nut (3) on the parking brake lever output cable until 22 millimeters (0.87 in.) of thread (1) is out past the end of the

adjustment nut.

c. Actuate the parking brake lever to its fully applied position one time, then reposition it to its fully released (down) position.

16. Raise the vehicle to a point where the rear wheels just clear the floor.
17. Check the rear wheels of the vehicle; they should rotate freely without dragging.
18. Apply the parking brake. Check the rear wheels of the vehicle. They should not rotate.
19. Return the parking brake lever to its fully released (down) position and check the rear wheels. They should rotate freely without dragging.
20. Apply the parking brake.
21. Lower the vehicle.

Parking Brake Cable|Removal|Page 5004 > < Parking Brake Cable|Removal|Page 5002