Avenger V6-2.7L Flex Fuel (2009)
NOTE: To reset the primary timing chain tensioner, engine oil will first need to be purged from the tensioner.
14. Purge oil from the timing chain tensioner using the following procedure:
a. Place the check ball (2) end of the tensioner into the shallow end of Chain Tensioner Gauge 8186 (3).
b. Using hand pressure, slowly depress the tensioner until oil is purged from the tensioner.
15. Reset the timing chain tensioner using the following procedure:
a. Position the cylinder plunger (4) into the deeper end of Chain Tensioner Gauge 8186 (3).
b. Apply a downward force until tensioner is reset.
NOTE: If oil was not first purged from the tensioner, use slight finger pressure to assist the center arm pin of Chain Tensioner Gauge 8186 to
unseat the tensioner's check ball.
CAUTION: Ensure the tensioner is properly reset. The tensioner body (4) must bottom against the top edge of Chain Tensioner Gauge 8186
(3). Failure to properly perform the resetting procedure may cause tensioner jamming.
NOTE: Inspect the tensioner O-ring (2) for nicks or cuts and make sure the snap ring (1) is correctly installed, replace as necessary.
