Avenger V6-2.7L Flex Fuel (2009)
4. Using a lint free towel, wipe clean the open power steering pressure hose end and the power steering pump port. Replace any used O-rings with
new. Lubricate the O-ring with clean power steering fluid.
5. Install the pressure hose (2) at the pump pressure port. Tighten the tube nut to 32 Nm (24 ft. lbs.).
6. Install the return hose (1) at the return tube (2) and install the clamp. If a screw-clamp is used, tighten it to 2.5 Nm (20 in. lbs.).
7. Lower the vehicle.
8. Fill and bleed the power steering system See: Steering and Suspension/Steering/Service and Repair/Steering - Power Steering System Bleeding.
9. Check for leaks.
Return Hose
INSTALLATION
