Avenger V6-2.7L Flex Fuel (2009)
Wheel Fastener: Service and Repair
Wheel Stud - Installation
Front
INSTALLATION
NOTE: Use the following procedure to install one of five studs on one wheel hub.
1. Install the NEW wheel mounting stud in the flange of the hub (2) from the rear.
2. Install several washers (1) and a standard wheel mounting (lug) nut (3) on the stud (4). Install the mounting nut so that the flat side of the nut is
against the washers to eliminate any binding.
3. Tighten the wheel mounting nut. This will pull the wheel mounting stud into the hub flange. When the head of the stud is fully seated against the
rear of the hub flange, remove the wheel mounting nut and washers.
4. Install the brake rotor and all components previously removed to access it. See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Removal and Replacement/Brake Rotor - Installation
Rear
INSTALLATION
NOTE: Use the following procedure to install one of five studs on one wheel hub.
1. Install the NEW wheel mounting stud in the flange of the hub (2) from the rear.
2. Install several washers (1) and a standard wheel mounting (lug) nut (3) on the stud (4). Install the mounting nut so that the flat side of the nut is
against the washers to eliminate any binding.