Avenger V6-2.7L Flex Fuel (2009)
Canister Purge Solenoid: Service and Repair
Installation
INSTALLATION
1. Install evaporator purge solenoid (1) to bracket. Make sure the tab (2) secures the solenoid (1) to the bracket.
2. Install quick connect fuel tank hose (3) to evaporator purge solenoid (1).
3. Install purge hose (4) to evaporator purge solenoid (1).
4. Connect electrical connector (5) to evaporator purge solenoid (1).
5. Install the PCM, See: Computers and Control Systems/Engine Control Module/Service and Repair/Removal and Replacement/Powertrain Control
Module - Installation.
6. Connect negative battery cable, tighten nut to 5 Nm (45 in. lbs.).