Avenger V6-2.7L Flex Fuel (2009)
3. Attach electrical connector to knock sensor.
4. Position the water housing outlet tube (4) to the cylinder heads and loosely install four bolts (1).
5. Attach water housing outlet tube (4) to the retaining clip (6) at rear of engine.
6. Tighten the four bolts (1) to 3 Nm (30 in. lbs.).
7. Connect electrical connector (2) to the coolant temperature sensor.
8. Install heater hose (5) to water housing outlet tube (4) at rear of engine.
9. Install radiator upper hose (3) to water housing outlet tube (4).
10. Install intake manifold See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Removal and Replacement/Intake Manifold
- Installation.
11. Connect negative battery cable, tighten nut to 5 Nm (45 in. lbs.).
12. Fill cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
13. Operate engine until it reaches normal operating temperature. Check cooling system for correct fluid levels.
