Avenger V6-2.7L Flex Fuel (2009)
2. Remove the B-pillar lower trim panel See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/B-Pillar Trim
Panel-Removal.
3. Disconnect the electrical connector (4) from the sensor (2).
4. Remove the screw (3) retaining the B-pillar (1) side impact sensor (2)
5. Remove the sensor (2) from the vehicle.
Side - C-Pillar
SIDE - C-PILLAR SENSOR
1. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components. Failure to do this may
result in serious or fatal injury.
2. Remove the rear quarter panel trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage Compartment
Trim/Quarter Trim Panel - Removal.
3. Remove the screw (4) that secures the side impact sensor (3) to the C-pillar (2).
4. Disconnect the electrical connector (1) from the sensor (3).
5. Remove the sensor (3) from the C-pillar.