Avenger V6-2.7L Flex Fuel (2009)
6. While a helper applies the brakes to keep the hub from rotating, remove the hub nut (1) from the right side axle half shaft (2).
7. Remove the drive belt splash shield.
8. Remove the drive belt. See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and
Repair/Removal and Replacement/Serpentine Accessory Drive Belt - Removal
9. Remove the nut (3) attaching the outer tie rod (6) to the right knuckle (2). To do this it might be necessary to hold the tie rod end stud with a
wrench while loosening and removing the nut with a standard wrench or crowfoot wrench.
10. Release the outer tie rod end (1) from the knuckle (3) using Remover (2), Special Tool 9360.
11. Remove the outer tie rod from the knuckle.
