Avenger V6-2.7L Flex Fuel (2009)
Steering Column Lock: Service and Repair
Shaft Lock Module - Installation
INSTALLATION
1. If not present, insert the ignition key into the ignition lock cylinder. This will move the shaft lock module locking bolt to the unlocked position.
Leave the key in the lock cylinder while the shaft lock module service is being completed.
2. Connect the wiring harness connector to the module.
3. Align the engagement and slide tabs (2) on the shaft lock module housing (1) with the slots and channels in the mounting bracket (3) on the
steering column.
4. Carefully slide the module toward the top (steering wheel end) of the column until it is in mounted position and the spring clips on the module
have engaged the bracket, locking it in place.
5. Install the steering column cover reinforcement (1) using the four mounting screws (2).
6. Install the steering column opening cover. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Steering Column Opening Cover - Installation
NOTE: If a NEW module has been installed, a NEW SKREEM (WCM) must also be installed, then a diagnostic scan tool MUST be used to
initialize the new module before the vehicle can be operated. See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Service and Repair .
