Avenger V6-2.7L Flex Fuel (2009)
7. If equipped with rear disc brakes, slide the disc brake caliper (2) and adapter (3) assembly over brake rotor and brake support plate.
8. If equipped with rear disc brakes, install the two bolts (1) securing disc brake caliper adapter (3) to the brake support plate (4). Tighten the
mounting bolts to 105 Nm (77 ft. lbs.).
9. Position the brake tube routing bracket at the knuckle and install the mounting screw. Tighten the screw to 15 Nm (11 ft. lbs.).
10. Install the tire and wheel assembly (1) See: Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation.
Install and tighten the wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
11. Lower the vehicle.
12. Position the vehicle on an alignment rack/drive-on lift. Raise the vehicle as necessary to access yet to be tightened mounting bolts and nuts.
13. Tighten the upper control arm bolt nut at the knuckle to 105 Nm (77 ft. lbs.).
14. Tighten the lower control arm bolt nut at the knuckle to 105 Nm (77 ft. lbs.).
15. Tighten the toe link mounting bolt nut at the knuckle to 105 Nm (77 ft. lbs.).
16. Perform wheel alignment as necessary. See: Alignment/Service and Repair
