Avenger V6-2.7L Flex Fuel (2009)
4. Ensure the transaxle oil pan and transaxle case sealing surfaces are clean and dry. Install an 1/8" bead of Mopar(R) Silicone Rubber Adhesive
Sealant to the oil pan and install.
5. Torque oil pan-to-transaxle case bolts to 19 Nm (165 in. lbs.).
6. Lower vehicle.
7. Connect transmission range sensor connector.
8. Install manual valve lever to manual shaft.
9. Install gearshift cable to manual valve lever.
10. Connect battery negative cable.
11. Fill transaxle with Mopar(R) ATF +4 Transmission fluid. . See: Fluid Filter - A/T/Service and Repair/41TE Automatic Transaxle
Valve Body - Removal
REMOVAL
1. Remove the engine cover.
2. Remove the negative battery.
3. Drain the radiatorSee: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
4. Remove clamps at the lower radiator hose.
5. Remove the lower radiator hose.
6. Remove shift cable (1) from manual lever (2).
