Avenger V6-3.5L (2008)
a.
No >>> This bulletin does not apply, further diagnosis is required.
b.
Yes >>> Perform the Repair Procedure.
SPECIAL TOOLS/EQUIPMENT REQUIRED:
REPAIR PROCEDURE:
1.
Move the affected seat to the full forward position.
2.
Insert flat blade screwdriver or small pry bar between movable and stationary seat track at rear edge of track (Fig. 2).
NOTE:
Care should be taken not to over-adjust the track lip as this will cause interference on the other side of the upper track rail.
CAUTION:
Only slight adjustment is necessary. Pry lip of seat track just enough to achieve 0.5mm (0.020 In) of clearance.
3.
Carefully pry the stationary rail lip toward the center of the seat by prying with screwdriver toward the outside of the seat track providing
additional rail to rail clearance of 0.5mm (0.020 In) (Fig. 2).
4.
Move the seat to the full rear position and verify clearance between rails.
5.
Repeat for other affected seat track(s) as necessary.
POLICY:
Reimbursable within the provisions of the warranty.
