Avenger V6-3.5L (2008)
5. Using Mopar(R) Lubriplate, or an equivalent, coat the surface of the brake pedal pin (3) where it contacts the brake booster push rod (1).
6. Install the power brake booster push rod (1) on the pin (3) mounted on the side of the brake pedal. Install a NEW retaining clip (2) on the end of
the pin. Do not reuse the old clip.
CAUTION: Do not reuse the original stop lamp switch. The switch can only be adjusted once. That is during initial installation of the switch. If
the switch is not adjusted properly or has been removed for some service, a new switch must be installed and adjusted.
7. Install and adjust a NEW stop lamp switch (2) in the brake pedal bracket (1). See: Lighting and Horns/Brake Light Switch/Service and
Repair/Installation
