Avenger V6-3.5L (2008)
4. Mount the caliper in a vise equipped with protective jaws.
WARNING: Do not place face or hands near caliper and piston if using compressed air pressure to remove piston. Do not use high
pressure.
5. Place a wooden block (2) in the caliper as shown.
6. As necessary, apply low pressure compressed air to the caliper fluid inlet in short spurts to force the piston (1) out.
7. Remove the piston (with dust boot) from the caliper.
8. Remove the dust boot from the piston and discard it.
CAUTION: Do not use a screw driver or other metal tool for seal removal. Using such tools can scratch the bore or leave burrs on the seal
groove edges.
9. Using a soft tool such as a plastic trim stick (2), work the piston seal (1) out of its groove (3) in the caliper piston bore. Discard the used seal.
10. Clean the piston bore and drilled passage ways with alcohol or a suitable solvent. Wipe it dry using only a lint-free cloth.
11. Inspect both the piston and bore for scoring or pitting. Bores that show light scratches or corrosion can usually be cleared of the light scratches or
corrosion using crocus cloth.
Front
