Avenger V6-3.5L (2008)
Brake Shoe: Procedures
Cleaning
CLEANING
WARNING:
DaimlerChrysler does not manufacture any vehicles or replacement parts that contain asbestos. Aftermarket products may or may not contain
asbestos. Refer to aftermarket product packaging for product information.
Whether the product contains asbestos or not, dust and dirt can accumulate on brake parts during normal use. Follow practices prescribed by
appropriate regulations for the handling, processing and disposing of dust and debris.
Inspection
INSPECTION
Inspect the shoe linings. Rear brake shoe linings should show contact across the entire width of the lining and also from the heel to the toe of the lining.
Replace the shoes if noted otherwise. Brake shoes with lack of contact at the toe or heel of the brake shoe lining may be improperly ground.
Clean and inspect the brake support plate and shoe adjuster screw. Apply a thin coat of Mopar(R) Multi-Purpose Grease or equivalent to the threads of
the self-adjuster. Replace the adjuster screw if it is corroded.
NOTE: Adjuster screws are different side-to-side. Left side adjuster screws have left-hand threads and right side adjuster screws have
right-hand threads.
Inspect the return springs and hold-down spring clips. If the existing brake shoe return springs or hold-down spring clips have been overheated or
damaged, replace them. Overheating indications are paint discoloration or distorted end coils.
