Avenger V6-3.5L (2008)
1. Install the wheel cylinder onto the brake support plate. Install and tighten the mounting screws (1) to 13 Nm (115 in. lbs.).
2. Hand start the brake tube nut (2) into the wheel cylinder (1). Tighten the tube nut to 17 Nm (150 in. lbs.).
NOTE: Inspect the brake shoes before installation. See: Disc Brake System/Brake Pad/Service and Repair/Procedures/Brake Pads - Inspection
3. Install the drum brake shoes (6) and drum. Adjust shoes as necessary. See: Disc Brake System/Brake Pad/Service and Repair/Removal and
Replacement/Brake Pads - Installation
