Avenger V6-3.5L (2008)
3. Using the chamfered seal guide from Special Tool 6926, insert the tapered end (1) into the transmission side of the rear crankshaft oil seal
assembly (2), and push the seal guide through the seal assembly. This will ensure the seal lip is positioned toward the engine when the seal
assembly is installed. When the seal lip is correctly positioned, Go to STEP 2.
NOTE: The following steps must be performed to prevent oil leaks at sealing joints.
4. Attach Special Tools 8225 (1) to pan rail using the oil pan fasteners.
NOTE: Special Tools 8225 (1), are use to assist with the fit of the flush mount rear main seal retainer. The notch on tool should be located
away the seal retainer.
5. While applying firm pressure to the seal retainer against Special Tools 8225 (1), tighten seal retainer screws to 12 Nm (105 in. lbs.).
6. Remove special tool #8225 (1).
NOTE: Make sure that the seal flange is flush with the block oil pan sealing surface.
7. Install oil pan. Tighten the 6mm fasteners to 12 Nm (105 in.lbs.) and the 8mm fasteners to 28 Nm (250 in.lbs.).
8. Install the flex plate and transmission.
