Avenger V6-3.5L (2008)
2. Install the upper heat shield (2), and torque nuts (1) to 12 Nm (105 in.lbs).
3. Install and connect the front upper maniverter oxygen sensor.
4. Position the oil level indicator tube and install the retaining bolt.
5. Install and connect the front lower maniverter oxygen sensor.
6. Install the maniverter cross under pipe retaining bolts. Tighten bolts to 31 N.m (275 in. lbs.).
7. Install the belly pan (2) and the 12 belly pan fasteners (1).
8. Connect the negative battery cable See: Starting and Charging/Battery/Service and Repair/Procedures/Battery Reconnection.
Rear Exhaust Maniverter
INSTALLATION - REAR EXHAUST MANIVERTER
1. Clean gasket surfaces.
2. Position the maniverter and gasket. Install the retaining bolts. Tighten bolts starting at the center working outward to 23 N.m (200 in. lbs.).
3. Install and connect the rear maniverter upper oxygen sensor.
4. Install the rear maniverter upper heat shield.
5. Install the rear maniverter lower heat shield.
6. Install and connect the rear maniverter lower oxygen sensor.
7. Install the front extension pipe.
8. Install the exhaust maniverter cross under pipe See: Exhaust Pipe/Service and Repair/Cross Pipe - Installation.
9. Install the center crossmember See: Body and Frame/Frame/Cross-Member/Front Cross-Member/Service and Repair.
10. Install the bracket to bell housing retainer.
11. Position the extension pipe and install the retainer nuts.
12. Install the right front half shaft See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Half
Shaft - Installation.
