Avenger V6-3.5L (2008)
13. Install the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -
Installation.
Instrument Panel Demister Ducts - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
NOTE: Take the proper precautions to protect the front face of the instrument panel from cosmetic damage while performing this procedure.
NOTE: LHD Chrysler model shown in illustrations. Dodge and RHD models similar.
DRIVER SIDE
1. Remove the instrument panel and place it on a workbench See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Instrument Panel - Removal.
2. Remove the left and right instrument panel air outlets See: Air Register/Service and Repair/Air Outlets - Removal.
3. Remove the outer instrument panel ducts See: Instrument Panel Ducts - Removal.
4. Remove the instrument panel top pad See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument
Panel Pad - Removal.
5. Remove the two screws (1) that secure the driver side demister duct (2) to the instrument panel top cover (3).
6. Disconnect the driver side demister duct from the defroster duct (4) and remove the demister duct.
PASSENGER SIDE
