Avenger V6-3.5L (2008)
NOTE: Take the proper precautions to protect the front face of the center bezel from cosmetic damage while performing this procedure.
2. If servicing a center air outlet, remove the center bezel and place it on a workbench See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Instrument Panel Center Bezel - Removal, then remove the outlet from the back of the bezel by disengaging
the retaining clips.
Dodge Models
DODGE MODELS
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
NOTE: Take the proper precautions to protect the front face of the trim panels from cosmetic damage while performing these procedures.
NOTE: LHD passenger air outlet shown. RHD and other instrument panel air outlets similar.
1. If servicing the passenger side air outlet, remove the passenger trim bezel from the instrument panel and place it on a workbench See: Body and
Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Passenger Side Bezel/Removal.
2. If servicing the driver side air outlet, remove the cluster bezel from the instrument panel and place it on a workbench See: Instrument Panel,
Gauges and Warning Indicators/Instrument Cluster / Carrier/Service and Repair/Instrument Panel Cluster Bezel/Instrument Panel Cluster Bezel -
Removal.
3. If servicing a center air outlet, remove the center bezel from the instrument panel and place it on a workbench See: Body and Frame/Interior
Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Center Bezel - Removal.
4. Carefully disengage the four retaining clips (2) that secure the air outlet (1) to the trim panel (3) using a trim stick or other suitable wide flat-blade
tool and remove the outlet.
