Avenger V6-3.5L (2008)
Hose/Line HVAC: Service and Repair
A/C Line - Installation
Discharge Line
INSTALLATION
CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system See: Service and
Repair/Procedures/Refrigerant Oil Level. Failure to properly adjust the refrigerant oil level will prevent the A/C system from operating as
designed and can cause serious A/C compressor damage.
NOTE: When replacing multiple A/C system components, refer to the Refrigerant Oil Capacities chart to determine how much oil should be
added to the refrigerant systemSee: Service and Repair/Procedures/Refrigerant Oil Level.
NOTE: Replacement of the refrigerant line O-ring seals and gaskets is required anytime a refrigerant line is opened. Failure to replace the
rubber O-ring seals and metal gaskets could result in a refrigerant system leak.
1. If removed, install the A/C pressure transducer (6) onto the A/C discharge line (2). Tighten the A/C pressure transducer securely.
2. Position the A/C discharge line into the engine compartment.
3. Remove the tape or plugs from the discharge and jumper line fittings.
4. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it and a new gasket onto the discharge line fitting. Use only the specified
O-ring as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the
vehicle.
5. Connect the A/C discharge line to the jumper line (4).
6. Install the nut (3) that secures the A/C discharge line to the jumper line. Tighten the nut to 18 Nm (13 ft. lbs.).
7. Connect the wire harness connector (1) to the A/C pressure transducer.