Avenger V6-3.5L (2008)
NOTE: Use only wire ties with nylon locks, not metal.
3. Working from the back side of the power steering pulley, insert a nylon wire tie, 7.75X1/8x0.50 in., through one of the holes in the pulley.
4. Tighten the wire tie to hold the drive belt in position.
5. While holding the drive belt to make sure it stays in position, slowly rotate the engine clockwise.
6. Once the belt is in position on the pulley, continue rotating the engine until the wire tie snaps.
7. Remove the wire tie from the vehicle.
8. Install right front inner wheel splash shield.
Accessory Drive Belt - Removal
3.5L ENGINE
CAUTION: Do not let tensioner arm snap back to the freearm position, sever damage may occur to the tensioner.
Belt tension is not adjustable. Belt adjustment is maintained by an automatic, spring loaded belt tensioner.
1. Disconnect negative battery cable from battery.
2. Rotate belt tensioner clockwise until it contacts it's stop. Remove belt, then slowly rotate the tensioner into the freearm position.
Accessory Drive Belt - Installation
3.5L ENGINE
