Avenger V6-3.5L (2008)
6. Using a lint free towel, wipe clean the open power steering pressure hose end and the power steering pump port. Replace any used O-rings with
new. Lubricate the O-ring with clean power steering fluid.
7. Install the pressure hose (1) at the power steering pump (4). Tighten the tube nut (3) to 32 Nm (24 ft. lbs.).
8. Position the pressure hose (1) routing clamp at the engine cylinder head. Install and tighten the routing clamp bolt (2) to 22 Nm (16 ft. lbs.).
9. Fill and bleed the power steering system. See: Steering and Suspension/Steering/Power Steering/Power Steering Bleeding/Service and Repair
10. Check for leaks.
Return Hose
INSTALLATION
1. Install the power steering return hose (7) into the engine compartment.
2. Install the return hose routing clamp screw (1) securing the return hose (7) to the body.
3. Raise and support the vehicle. See:
4. Install the return hose routing clamp screw (6) securing the return hose (7) to the frame rail. Tighten the screw to 8 Nm (71 in. lbs.).
5. Install the screws (3) securing the return hose to the frame rail (2). Tighten the screws to 8 Nm (71 in. lbs.).
6. Install the return hose onto the cooler line (4) and install the hose clamps (5).
