Avenger V6-3.5L (2008)
7.
Remove the seat track position sensor from the seat track by pressing on the sensor release arm while pulling the sensor forward (Figure 3).
8.
Check the date code on the seat track position sensor (Figure 4):
>
If the date code on the sensor is 099 or lower or 107 or higher, the sensor is good.
>
If the date code on the sensor is between 100 and 106, the sensor must be replaced.
9.
Install the sensor onto the seat track mounting tab by sliding the seat track position sensor rearward until the lock tab engages.
10.
Connect the gray electrical connector to the seat track position sensor.
11.
Push the red lock tab on the gray electrical connector rearward to engage the lock.
12.
Repeat steps 2 through 11 on the passenger side front seat.
13.
Ensure that no one is sitting or leaning into the front seat area of the vehicle.
