Avenger V6-3.5L (2008)
1. Connect wire harness connectors to retractor (5 - tensioner squib and seat belt switch).
2. Place retractor and belt assembly into position and install the mounting bolt to B-pillar. Tighten bolt to 52 Nm (38.5 ft. lbs.).
3. Install turning loop and bolt onto height adjuster (1). Tighten bolt to 52 Nm (38.5 ft. lbs.).
4. Feed end of seat belt (2) through B-pillar trim (3) and install B-pillar trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and
Repair/Pillar Trim/B-Pillar Trim.
5. Place seat belt webbing anchor (3) into position on the seat cushion frame (4) and install the bolt (2). Tighten to 47 Nm (34.5 ft. lbs.).
6. Install the side shield/cover (1) to the seat belt anchor (3).
WARNING: Do not connect the battery negative cable See: Air Bag Systems/Testing and Inspection. Serious or fatal injury may result if
the system test is not performed first.
