Avenger V6-3.5L (2008)
Wheel Speed Sensor: Service and Repair
Rear Wheel Speed Sensor - Installation
All-Wheel-Drive
ALL-WHEEL-DRIVE
CAUTION: Failure to install speed sensor cables properly may result in contact with moving parts or an over extension of cables causing an
open circuit. Be sure that cables are installed, routed, and clipped properly.
NOTE: When installing the sensor head to the spring-loaded retainer on the hub and bearing, make sure the head is held snug in the retainer.
If there is any play, the clip is deformed and the hub and bearing must be replaced. The retainer is not serviced separately.
1. Clip the wheel speed sensor head (1) (flat side to bearing rear face) into the spring-loaded retainer on the rear of the hub and bearing (2).
2. Position the wheel speed sensor (3) on the trailing link and install the screw securing it in place. Tighten the mounting screw to 18 Nm (13 ft. lbs.).
3. Position the wheel speed sensor (3) and install the routing clips (4) fastening the sensor to the trailing link.
