Avenger V6-3.5L (2008)
9. Connect the wheel speed sensor cable connector (1) to the body wiring harness connector (2).
10. Reposition the luggage compartment carpet as necessary.
11. Perform the Diagnostic Verification Test and clear any faults. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests
FWD
FRONT-WHEEL-DRIVE
CAUTION: Failure to install speed sensor cables properly may result in contact with moving parts or an over extension of cables causing an
open circuit. Be sure that cables are installed, routed, and clipped properly.
1. Install the wheel speed sensor (2) head into the rear of the hub and bearing.
2. Install the wheel speed sensor head mounting screw (1). Tighten the screw to 10 Nm (89 in. lbs.).