Avenger V6-3.5L (2008)
Wiper Switch: Service and Repair
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove both the upper and lower shrouds from the steering column See: Steering and Suspension/Steering/Steering Column/Steering Column
Cover/Service and Repair/Shroud - Upper/Removal and See: Steering and Suspension/Steering/Steering Column/Steering Column Cover/Service
and Repair/Shroud - Lower/Removal.
3. Remove the screw (2) that secures the right multi-function switch (1) to the mounting bracket integral to the right side of the clockspring (3) on the
steering column.
4. Slide the switch away from the clockspring far enough to disengage the slide tab on the bottom of the switch housing from the channel formation
in the mounting bracket.
5. Disconnect the jumper wire harness connector (1) from the connector receptacle on the inboard end of the right multi-function switch (2).
6. Remove the switch from the clockspring (3).