Avenger V6-3.5L (2008)
5. While holding the steering wheel firmly in place, remove the retaining bolt (2) securing the steering wheel to the steering column shaft.
CAUTION: When installing a wheel puller on the steering wheel, be sure the puller jaws are fully seated around the steering wheel base (1). If
the jaws are not fully seated, the jaws may slip off the steering wheel while attempting to remove the steering wheel.
Also, threading the retaining bolt (2) back in the end of the shaft until approximately 13 mm (0.5 in.) of thread is showing between the wheel
and the head of the bolt allows a safe reaction surface for the puller to work against.
6. Thread the wheel retaining bolt (2) back into the end of the shaft until approximately 13 mm (0.5 in.) of thread is showing between the wheel and
the head of the bolt.
7. Remove the screw (3) for the speed control switch in order to install the steering wheel puller tool.
8. Install a steering wheel puller on the steering wheel.
CAUTION: Do not bump or hammer on steering wheel or steering column shaft when removing steering wheel from steering column.
9. While holding the steering wheel firmly in the STRAIGHT-AHEAD position, remove steering wheel from the steering column shaft using the
puller.
10. Remove the wheel retaining bolt (2) and the steering wheel.
