Avenger V6-3.5L (2008)
Tie Rod End: Service and Repair
Tie Rod End - Installation
OUTER TIE ROD END
1. If it is not already installed, install the jam nut on the inner tie rod threads. Thread the jam nut down the inner tie rod far enough to allow for outer
tie rod installation.
2. Thread the outer tie rod onto the inner tie rod approximately the same amount of revolutions as the original was installed. Do not tighten the jam
nut at this time.
3. Install the outer tie rod end (6) into the hole in the knuckle (2) arm. Start a NEW tie rod mounting nut (3) onto the stud. While holding the tie rod
end stud with a wrench, tighten the nut with a wrench or crowfoot wrench. Tighten the nut to 85 Nm (63 ft. lbs.).
4. Install the tire and wheel assembly (1)See: Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation. Install
and tighten wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
5. Lower the vehicle.
6. Adjust the front wheel toe setting. See: Alignment/Service and Repair.
7. Tighten the tie rod jam nut to 75 Nm (55 ft. lbs.) once wheel toe is set.