Avenger V6-3.5L (2008)
11. Through the access hole (1) in the knuckle, tap the ends of the snap-ring (2) with a drift punch and remove it from the ball joint.
12. Install Remover (2), Special Tool 9964-3, and Remover (4), Special Tool 9964-4 on Remover/Installer (5), Special Tool 8441-1. Place the tools
over the ball joint (3) as shown, then hand tighten the screw-drive.
13. Using hand-tools, tighten the screw-drive forcing the ball joint (3) out of the knuckle (1).
14. Loosen the screw-drive and remove the tools and ball joint.