Avenger V6-3.5L (2008)
6. Attach the stabilizer bar link (1) at each end of the stabilizer bar (2). At each link, install and tighten the nut (3) while holding the stabilizer bar
link lower stud stationary. Tighten the nuts to 48 Nm (35 ft. lbs.).
NOTE: If a new or cleaned lower control arm is being installed, it is important to have a film of general purpose grease around the ball
joint mounting hole on the lower control arm to avoid any future corrosion issues. Make sure the grease does not get inside the ball joint
mounting hole or on the ball joint stud during installation.
7. Insert the lower ball joint stud into the mounting hole in the lower control arm (5).
8. Install a NEW ball joint stud nut (4). Tighten the nut to 95 Nm (70 ft. lbs.).
