B250 3/4 Ton Van V8-318 5.2L VIN T FI (1992)
Windshield Header, A-Pillar & Front Door Header Trim Panels
1. Remove the sunvisor and retaining clip attaching screws from the windshield header. Remove the visors and clips from the windshield header.
2. Remove the trim panel attaching screws from the body interior panels.
3. Remove the trim panels from the body interior panels.
INSTALLATION
To ensure correct alignment when installing interior trim panels, first install the attaching screws "finger-tight", align the trim panel at each end
and then tighten the screws with the specified torque. Avoid over-tightening the attaching screws because this can damage the trim panel and/or the
body panel screw holes.
1. Position the trim panels at the body interior panels with the screw holes aligned.
2. Install the trim panel attaching screws in the body interior panels. Tighten the screws with 2 Nm (17 in. lbs.) torque. Avoid over-tightening the
screws.
3. Position the sunvisors and retaining clips on the windshield header with the screw holes aligned.
4. Install the attaching screws in the windshield header. Tighten the screws with 2 Nm (17 in. lbs.) torque. Avoid over-tightening the screws.
SIDE CARGO DOOR HEADER AND PILLAR TRIM PANEL REMOVAL
When removing an interior trim panel that is overlapped by an adjacent trim panel, remove the nearest attaching screw in the adjacent trim panel to
avoid possible damage to both panels.
Side Cargo Door Header & Pillar Trim Panels
1. If applicable, remove the front door header trim panel end attaching screw from the door header.
2. Remove the trim panel attaching screws from the body interior side panels.
3. Remove the trim panels from the body interior panels.
INSTALLATION